kukko 204-3 2-arm bearing puller 150 x 140 mm with side clamp for pulling particularly stuck ball bearings, bearing rings, and workpieces Drill Bits and stainless steel cable up

and stainless steel cable up to 5/8 in thick

The self-locking arms minimise the risk of the puller slipping from the application when under load

Range 1500 V / Basic accuracy ±2

Specification Details Model NCB10 Power Supply 100-240V / 50-60 Hz Flow Rate 10

kukko 204-3 2-arm bearing puller 150 x 140 mm with side clamp for pulling particularly stuck ball bearings, bearing rings, and workpieces Drill Bits and stainless steel cable upThe 2 jaw bearing puller "Cobra" with side clamp is used for pulling particularly stuck ball bearings, bearing rings, and workpieces. With this, it is possible to loosen any component that is mounted on a shaft and is freely accessible from the outside. Thanks to the clamp, the contact pressure of the puller jaws is increased manifold. When the clamp is tightened, the sharp claws of the puller jaws grip underneath the part to be pulled off and loosen