SKF FRB 10.5/90 Locating Ring - 82 mm ID, 90 mm OD, 10.5 mm Width Hydraulic Cylinder The ball joint puller of

The ball joint puller of the series 127-A is used to press out the ball studs when removing ball joints and steering tie rod ends on tie rods

The combination of oil hooks and sliding hammer allows for a felt or powerful striking or loosening of difficult-to-remove parts in vehicles and machines

This allows for the removal of any component that sits on a shaft and is freely accessible from the outside

The Whittet-Higgins RTDM-02 is a metric rethreading die used to clean

SKF FRB 10.5/90 Locating Ring - 82 mm ID, 90 mm OD, 10.5 mm Width Hydraulic Cylinder The ball joint puller ofLocating Ring SKF locating rings provide axial positioning for bearings within housings. They are precision manufactured to ensure accurate bearing location and reliable retention. Easy to install, they simplify bearing arrangement assembly.